NEC Express5800/120Rh-2 N8100-1061F User Manual page 73

After taking out the CD-ROM, return the tray into the drive.
When you fail to eject the CD-ROM tray with the Eject button and take out the CD-ROM from the
server, follow the procedure below.
1.
Press the POWER switch to power off the server. (The POWER LED goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip will make a substitute) into the emergency hole on the right
front of the CD-ROM drive and gently push it in until the tray is ejected.
IMPORTANT:
Do not use a toothpick or plastic stick that is easy to break.
If the above procedure does not let you take out the CD-ROM,
contact your service representative.
3.
Hold the tray and pull it out.
4.
Take out the CD-ROM.
5.
Push the tray back into position.
General Description 2-41
Emergency hole