NEC Express5800/120Rh-2 N8100-1061F User Manual page 341

Write-protection
A floppy disk has a write-protect switch that prevents the stored data from accidental
erasure.
You can read data from a write-protected floppy disk, but you cannot save data into the
floppy disk or format it. NEC recommends that you should write-protect any floppy disk
containing valuable data unless you are about to save data.
To write-protect a 3.5-inch floppy disk, use the write-protect switch provided on its back.
Disk format
To write data into a floppy disk, the floppy disk must be "formatted." "Formatting" is to
initialize the floppy disk and make it available for the system environment (operating
system).
IMPORTANT:
Formatting a used floppy disk clears all the data contained in it, if
any.
Formatting a floppy disk from the DOS command line is not
available with the server. Use a formatted floppy disk to work
with it on the DOS command line.
The format method depends on your operating system. Refer to the manual that comes
with your operating system for details.
Data backup
"Data backup" is to copy data stored in a media into another media (e.g., floppy disk,
digital audio tape, or magnet-optical disk).
IMPORTANT:
disk, if provided.
The floppy disk is a very delicate storage media. Dust or thermal changes, as well as
operator's misconduct or server failures, may cause loss of data. To avoid loss of data,
NEC recommends that you should make a back-up copy of your valuable data on a
regular basis.
Make sure to make a back-up copy of every floppy
Other Precautions B-3