NEC Express5800/120Rh-2 N8100-1061F User Manual page 370

E-8 Installing Windows Server 2003
7.
Select the proper SCSI Adapter and press Enter.
– Adaptec HostRAID U320 Driver Ver 1.02 For Windows 2000/XP/2003
(When Adaptec HostRAID (SCSI) is installed.)
– MegaRAID SCSI 320-1 RAID Controller Driver (When N8103-80F board is installed.)
– MegaRAID SCSI 320-2 RAID Controller Driver (When N8103-81F board is installed.)
– Adaptec I2O RAID Driver Disk for 32bit Windows 2000/XP/2003
(When N8103-86 board is installed.)
– LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)
(When N8103-91 board is installed.)
Continue performing tasks according to the subsequent messages that appear.
8.
When the following message is shown, press Enter to start "Welcome to Setup".
9.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has been installed: Go on the step 13.
– Windows Server 2003 R2 has been installed: Go on the step 10.
10.
When Windows Server 2003 R2 has been installed, the [Windows setup] screen will be
displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
You can install Microsoft Windows Server 2003 R2 DISC 2 after
the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 DISC 2.
In this case, note that the [Windows setup] screen is not displayed.
11.
Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the CD-ROM drive.
Confirm the parameters and click [OK].
12.
When the installation has completed, remove Microsoft Windows Server 2003 R2 DISC 2
CD-ROM from the CD-ROM drive, and restart the system.
13.
When the installation has completed, be sure to execute the tasks described in "Driver
Installation and Advanced Settings" and "Updating the System" of manual.