NEC Express5800/120Rh-2 N8100-1061F User Manual page 111

Server
Option
System
Management
Console
Redirection
Event Log
Configuration
Assert NMI on
PERR
Assert NMI on
SERR
FRB-2 Policy
Boot Monitoring
Boot Monitoring
Policy
Thermal Sensor
Parameter Description
– System Management submenu is
displayed.
– Console Redirection submenu is
displayed.
– Event Log Configuration submenu is
displayed.
Disabled Specify whether to support PCI PERR or
[Enabled] not.
Disabled Specify whether to support PCI SERR or
[Enabled] not.
Disable FRB2 Set the FRB level 2 timer.
Timer
[Retry 3 Times]
[Disabled] Specify whether to enable or disable the
boot monitoring function on booting, or
5 Minutes
select the time limit for timeout.
10 Minutes
To use this function, install NEC
15 Minutes
ESMPRO Agent. Set this item to
20 Minutes
"Disabled" if the system is booted from
25 Minutes
OS without installation of NEC
30 Minutes
ESMPRO Agent.
35 Minutes
40 Minutes
45 Minutes
50 Minutes
55 Minutes
60 Minutes
[Retry 3 Times] Specify the processing at the
occurrence of timeout during boot
Retry Service
monitoring.
Boot
If [Retry 3 times] is selected, the system
Always Reset
is reset after the occurrence of timeout
and OS boot is retried up to three times.
If [Retry Service Boot] is selected, the
system is reset after the occurrence of
timeout and OS boot is retried up to
three times. Then the boot is tried from
the service partition for three times. The
failure in the third boot causes the
system to stop booting.
If [Always Reset] is selected, the system
is reset after the occurrence of timeout
and OS boot is retried repeatedly.
* If no service partition exists in the
Disabled Specify whether to enable or disable the
thermal sensor monitoring function. If a
[Enabled]
thermal error is detected with this item
being set to "Enabled", the system stops
at the end of POST.
system, OS boot is retried repeatedly
from the system partition.
Configuring Your Server 4-15
Your Setting