NEC Express5800/120Rh-2 N8100-1061F User Manual page 118

4-22 Configuring Your Server
SCSI Device Configuration
Move the cursor onto "SCSI Device Configuration" and press Enter to display the
submenu.
The following table lists submenu items, available parameters, and descriptions.
IMPORTANT:
SCSI ID basis. Verify the SCSI ID of a desired device before
configuration.
NOTE:
select "SCSI Disk Utilities" on the Options menu and press Enter.
See "SCSI Disk Utilities" for detail.
Submenu item
Sync Transfer Rate
(MB/Sec)
Packetized
QAS
Initiate Wide
Negotiation
Enable Disconnection
Send Start Unit
Command
BIOS Multiple LUN
Support
Include in BIOS Scan
Select a parameter for each submenu item on a per-
To find out the SCSI ID for the optional device connected,
Parameter
[320] 33.3
160 20.0
80.0 10.4
66.6 ASYN
40.0
[Yes]
No
[Yes]
No
[Yes]
No
[Yes]
No
[Yes]
No
Yes
[No]
[Yes]
No
Description
Select "320".
You may need to change the value
depending on your optional device.
Refer to the manual that comes with your
optional device for details.
Optimizes bus utilization and minimizes
command overhead to bolster performance
by transferring commands, data, and status
using Deal Transition (DT) data phases.
Quick Arbitration and Selection (QAS)
reduces the overhead of control release on
the SCSI bus from one device to another to
help decrease command overhead and
increase bus utilization.
Select "Yes" if your SCSI device supports the
Wide SCSI interface. Select "No" if not.
Select "Yes".
Select "Yes" to send the command to the
hard disk drive. Otherwise select "No".
Select "No".
Select "Yes".
[ ]: Factory-set