NEC Express5800/120Rh-2 N8100-1061F User Manual page 327

12.
Insert the device carrier into the backup device bay halfway.
Push the device carrier as far as it will go. It is locked when a "click" is heard.
NOTE:
Be careful not to catch the connected power extension cable in
inserting the device carrier.
13.
Connect the interface cable and power cable to the backplane as shown in figure below.
<IDE device>
NOTE:
Confirm where to place the terminator at the end of the SCSI
cable. The terminator must be placed in the device bay. At this time,
also confirm that the SCSI cable is not in contact with the latching tab
of the device carrier. This is to prevent the cable from being damaged.
14.
Insert the device carrier into the device bay until it locks.
Upgrading Your Server 9-53
<SCSI device>
SCSI Connector