NEC Express5800/120Rh-2 N8100-1061F User Manual page 353

7.
Select the proper SCSI Adapter and press Enter.
– Adaptec HOSTRAID driver for Windows XP/2003 x64 Edition
(When Adaptec HOSTRAID (SCSI) is installed.)
– MegaRAID SCSI 320-1 RAID Controller Driver
(When N8103-80F board is installed.)
– MegaRAID SCSI 320-2 RAID Controller Driver
(When N8103-81F board is installed.)
– LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 for x64)
(When N8103-91F board is installed.)
Continue performing tasks according to the subsequent messages that appear.
8.
When the following message is shown, press Enter to start "Welcome to Setup".
9.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 x64 Editions has installed: Go on the step 13
– Windows Server 2003 R2 x64 Editions has installed: Go on the step 10
10.
The [Windows setup] screen will be displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2 according to the following procedures.
You can install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2 after the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 x64 Edition
DISC 2.
In this case, note that the [Windows setup] screen is not displayed.
11.
Insert Microsoft Windows Server 2003 R2 x64 Edition DISC 2 CD-ROM into the CD-
ROM drive.
Confirm the parameters and click [OK].
12.
When the installation has completed, remove Microsoft Windows Server 2003 R2 x64
Edition DISC 2 CD-ROM from the CD-ROM drive, and restart the system.
13.
When the installation has completed, be sure to execute the tasks described in "Driver
Installation and Advanced Settings" and "Updating the System" of manual.
Installing Windows Server 2003 x64 Editions D-7