Planet MH-4000 User Manual page 121

Multi-Homing Security Gateway User's Manual
Step 2: Configure the parameters.
Source Address: Select names of the WAN networks from the drop down list. The drop down
list contains the names of all WAN networks defined in the WAN section of the Address menu.
To create a new source address, please go to the LAN section under the Address menu.
Destination Address: Select names of the LAN networks from the drop down list. The drop
down list contains the names of IP mapping addresses specified in the Mapped IP or the Virtual
Server sections of Virtual Server menu. To create a new destination address, please go to the
Virtual Server menu.
Service: Specified services provided by LAN network servers. These are services / application
that are allowed to pass from the network to the LAN network. Choose ANY for all services.
Action: Select Permit or Deny to allow or reject the packets travelling between the specified
WAN network and Virtual Server/Mapped IP.
Logging (Traffic Log): select Enable to enable flow monitoring.
Statistics: select Enable to enable flow statistics.
Schedule: Select the item listed in the schedule to enable the policy to automatically execute
the function in a certain time and range.
Alarm Threshold: set a maximum flow rate (in Kbytes/Sec). An alarm will be sent if flow rates
are higher than the specified value.
QoS: Select the item listed in the QoS to enable the policy to automatically execute the function
in a certain time and range. (Only available with MH-4000)
MAX. Concurrent Sessions: The maximum concurrent sessions that allows passing through
MH-2K/4K. 0 means it is unlimited.
- 116 -