Planet MH-4000 User Manual page 178

Disable PPTP Check to disable PPTP Server.
Enable PPTP Check to enable PPTP Server.
Encryption: the default is set to disabled.
Client IP Range: The range of the IP address will allocate to PPTP clients when they
connect to the PPTP server. The IP address is only for PPTP client connection using, so
it may not be the same IP subnet with MH-2K/4K's LAN IP subnet. You can just keep the
IP range as the default setting.
Auto-Disconnect if idle
Server when there is no activity for a predetermined period of time. To keep the line always
connected, set the number to 0.
Schedule Click the down arrow to select the schedule, which was pre-determined in
Schedule. Refer to the corresponding section for details.
Enable RADIUS Server Authentication: (Only available with MH-4000)
IP or Domain Name: the RADIUS IP address or domain name
RADIUS Server Port: the port number of the RADIUS, default port number is 1812.
Shared Secret: the Password for MH-4000 to access RADIUS Server.
Step 4. Click OK to save modifications or click Cancel to cancel modifications
Adding PPTP Server
Step 1. Select VPN→PPTP Server. Click New Entry.
Step 2. Enter appropriate settings in the following window.
User name: Specify the PPTP client. This should be unique.
Password: Specify the PPTP client password.
Remote Client:
Single Machine: Check to connect with single computer at each connection.
Multi-Homing Security Gateway User's Manual
minutes: Configure this device to disconnect to the PPTP
- 173 -