Planet MH-4000 User Manual page 115

Multi-Homing Security Gateway User's Manual
Step 2: Configure all the parameters.
Source Address: Select the name of the LAN network from the drop down list. The drop down list
contains the names of all LAN networks defined in the LAN section of the Address menu. To create a
new source address, please go to the LAN section under the Address menu.
Destination Address: Select the name of the WAN 1/2 network from the drop down list. The drop
down list contains the names of all WAN 1/2 networks defined in the WAN 1/2 section of the Address
window. To create a new destination address, please go to the WAN 1/2 section under the Address
menu.
Service: Specified services provided by WAN 1/2 net work servers. These are services/application
that are allowed to pass from the LAN network to the WAN 1/2 network. Choose ANY for all services.
Action: Select Permit ALL, Permit WAN 1, Permit WAN 2 or Deny ALL to allow or reject the packets
travelling between the source network and the destination network.
Logging (Traffic Log): Select Enable to enable flow monitoring.
Statistics: Select Enable to enable flow statistics.
Content Filtering (Content Blocking): Select Enable to enable Content Filtering.
Authentication User: Select the item listed in the Authentication User to enable the policy to
automatically execute the function in a certain time and range. (Only available with MH-4000)
Schedule: Select the item listed in the schedule to enable the policy to automatically execute the
function in a certain time and range.
Alarm Threshold: set a maximum flow rate (in Kbytes/Sec). An alarm will be sent if flow rates are
higher than the specified value.
QoS: Select the item listed in the QoS to enable the policy to automatically execute the function in a
certain time and range. (Only available with MH-4000)
MAX. Concurrent Sessions: The maximum concurrent sessions that allows passing through
- 110 -