Multi-Homing Security Gateway User's Manual
Step 2: Configure the parameters.
Source Address: Select the name of the DMZ network from the drop down list. The drop down
list will contain names of DMZ networks defined in DMZ section of the Address menu. To add a
new source address, please go to the DMZ section under the Address menu.
Destination Address: Select the name of the WAN network from the drop down list. The drop
down list lists names of addresses defined in WAN section of the Address menu. To add a new
destination address, please go to WAN section of the Address menu.
Service: Select a service from drop down list. The drop down list will contain services defined in
the Custom or Group section under the Service menu. These are services/application that are
allowed to pass from the DMZ network to the WAN network. Choose ANY for all services. To
add or modify these services, please go to the Service menu.
Action: Select Permit or Deny to allow or reject the packets travelling from the specified DMZ
network to the WAN network.
Logging (Traffic Log): Select Enable to enable flow monitoring.
Statistics: Select Enable to enable flow statistics.
Content Filtering: Select Enable to enable Content Filtering.
Schedule: Select the item listed in the schedule to enable the policy to automatically execute
the function in a certain time and range.
Alarm Threshold: set a maximum flow rate (in Kbytes/Sec). An alarm will be sent if flow rates
are higher than the specified value.
QoS: Select the item listed in the QoS to enable the policy to automatically execute the function
in a certain time and range.
- 124 -