Leds, Light Pipe, And Standby Switch - Intergraph InterServe 80 SL System Reference Manual

To replace the battery:
1. Remove any option cards that restrict access to the battery. See "Option Cards" in this
chapter for details.
2. Note the positive orientation of the battery. Carefully remove the discharged battery by
grasping it firmly and pulling it out of the socket.
3. Install the new battery in the same orientation as the old battery.
4. Dispose of the battery according to the manufacturer's instructions.
5. Install the option cards that you removed.

LEDs, Light Pipe, and Standby Switch

See the system board diagram in Chapter 5, "System Board," for connector and socket
locations. See also the "Cable Routing and Pinouts" section in Chapter 5 for LED and power
switch cable and connector details.
To replace an LED:
1. Remove the internal bay disk drives. See "Internal Bay Disk Drives" in this chapter for
details.
2. Note the locations of the two LEDs on the light pipe.
3. Remove the LED from its mount on the light pipe, then disconnect the LED cable from
its connector on the system board.
4. Remove the LED cable from the chassis.
5. Route the new LED cable through the chassis and connect it to the appropriate
connector on the system board.
6. Press the LED into its mount on the light pipe.
To replace the light pipe:
1. Remove the face panel. See "Base Unit Components" in this chapter for details.
2. Remove the internal bay disk drives. See "Internal Bay Disk Drives" in this chapter for
details.
3. Disconnect the LEDs from the light pipe.
29