Removal And Reinstallation Of The - Mitsubishi Electric Melservo-J3 Series MR-J3-B Instruction Manual

1. FUNCTIONS AND CONFIGURATION
1.7.2 Removal and reinstallation of the front cover
WARNING
(1) For MR-J3-350B4 MR-J3-500B(4) MR-J3-700B(4)
Removal of the front cover
Hold the ends of lower side of the front cover with
both hands.
Pull out the front cover to remove.
Before removing or installing the front cover, turn off the power and wait for 15
minutes or more until the charge lamp turns off. Then, confirm that the voltage
between P( ) and N( ) is safe with a voltage tester and others. Otherwise, an
electric shock may occur. In addition, always confirm from the front of the servo
amplifier whether the charge lamp is off or not.
A)
Pull up the cover, supporting at point A) .
1 - 18
A)