Battery Mr-J3Bat - Mitsubishi Electric Melservo-J3 Series MR-J3-B Instruction Manual

11. OPTIONS AND AUXILIARY EQUIPMENT
(b) Connection with servo amplifier
1) For use of USB

11.9 Battery MR-J3BAT

(1) Purpose of use for MR-J3BAT
This battery is used to construct an absolute position detection system. Refer to section 12.3 for the fitting
method, etc.
(2) Year and month when MR-J3BAT is manufactured
The year and month when MR-J3BAT is manufactured are written down in Serial No. on the rating plate of
the battery back face.
The year and month of manufacture are indicated by the last one digit of the year and 1 to 9, X(10), Y(11),
Z(12).
For October 2004, the Serial No. is like, "SERIAL
Servo amplifier
USB cable
MR-J3USBCBL3M
CN5
(Option)
CN2
POINT
The revision (Edition 44) of the Dangerous Goods Rule of the International Air
Transport Association (IATA) went into effect on January 1, 2003 and was
enforced immediately. In this rule, "provisions of the lithium and lithium ion
batteries" were revised to tighten the restrictions on the air transportation of
batteries. However, since this battery is non-dangerous goods (non-Class 9),
air transportation of 24 or less batteries is outside the range of the
restrictions. Air transportation of more than 24 batteries requires packing
compliant with the Packing Standard 903. When a self-certificate is necessary
for battery safety tests, contact our branch or representative. For more
information, consult our branch or representative. (As of July, 2007).
MELSERVO
3.6V,2000mAh
SERIAL
MITSUBISHI ELECTRIC CORPORATION
MADE IN JAPAN
The year and month of manufacture
To USB
connector
4X
MR-J3BAT
4X
11 - 64
Personal computer
".