Quick Start; Unpacking Your Fasttrak100 - Promise Technology FASTtrak100 TX User Manual

This section is designed to quickly get your FastTrak100 TX/LP series controller up
and running using the default settings, which will be optimal for most users. If you
wish to modify any of the default settings, please refer to page 14, Using FastBuild™
Configuration Utility.

Unpacking Your FastTrak100

When you receive the FastTrak100, the package should contain the items listed below:
FastTrak100 TX4, TX2, or LP Ultra ATA/100 RAID Card
FastTrak100 TX/LP Series User's Manual
FastTrak100 Driver floppy diskette
Two (TX2/LP models) or four (TX4) internal 80-wire/40-pin Ultra ATA/100 hard
drive cables (18" length)
If ANY of the contents are missing or appear to be damaged, please contact your
dealer or distributor immediately.
WARNING: Before installing the adapter into an existing system,
backup any necessary data. Failure to follow this accepted PC
practice could result in data loss.
NOTE: FastTrak100, like every other valuable part of your system, is subject to
static electricity. Be sure that you're properly grounded (Promise recommends that
you wear an anti-static strap, or touch a grounded object), and that your system is
unplugged before installing FastTrak100.
FastTrak100 TX/LP™ Series User Manual

Quick Start

5