Netware 5 - Promise Technology FASTtrak100 TX User Manual

Netware 5

For new NetWare 5 servers:
1. Start the Netware 5 installation as you normally would.
2. When you reach the point in the installation where you install storage
adapters, choose "Modify" in the "Options" window and press ENTER.
3. Highlight the "Storage Adapters" field and press ENTER.
4. Press the INSERT key on your keyboard to "Add" a device.
5. Insert the FastTrak100 driver disk into your A: floppy drive.
6. Press the insert key again to "Add an unlisted driver".
7. Press F3 and type "A:\NETWARE" in the "Specify a directory path:" window.
Press ENTER.
8. The FASTTRAK.HAM driver should be listed in the "Select a driver to install:"
window. Press ENTER to select this driver.
9. If you need to install any additional drivers for other storage adapters,
choose "Yes" in the "Do you want to select an addition al storage driver?"
window. If not, choose "No".
10. Choose "Return to driver summary" in the "Additional Driver Options"
window and press enter.
11. Choose "CONTINUE" in the options window and press ENTER.
12. Continue the installation as you would normally.
For existing NetWare 5 servers:
1. From the System Console type "load NWCONFIG".
2. Choose "Driver Options".
3. Choose "Configure disk and storage device drivers".
4. Choose "Select an additional driver".
5. Press the INSERT key on your keyboard.
6. Insert the FastTrak100 driver disk into your A: floppy drive.
7. Press F3 and type "A:\NETWARE" in the "Specify a directory path:" window.
Press ENTER.
FastTrak100 TX/LP™ Series User Manual
50