Dos/Windows 3.1X - Promise Technology FASTtrak100 TX User Manual

7. Choose "Yes" when asked whether you want to start your computer. Be
sure to remove the diskette from drive A:.
Confirming Driver Installation in Windows 98/95
To confirm that the driver has been properly loaded in Win 95/98, perform the
following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double -click on the "System" icon.
3. Choose the "Device Man ager" tab, and then click the "+" in front of "SCSI &
RAID controllers." "Win9x -ME Promise FastTrak100 TX/LP(tm) Series
Controller" should appear (2 listings will appear if you have the FastTrak100
TX4).

DOS/Windows 3.1x

For first-time installation, follow the standard procedure of installing DOS on to your
hard disk (partition all hard drives with FDISK and format before performing the
following procedure):
1. Insert "Disk 1" of your DOS installation diskettes into drive A:.
2. Type "A:SETUP" at the "A: \" promp t.
3. Continue with normal DOS installation procedure, and refer to your DOS
manual for additional details.
NOTE: The FastTrak100 BIOS supports both DOS and Windows 3.1x without
software drivers.
FastTrak100 TX/LP™ Series User Manual
45