Table of Contents
Advertisement
Installing Drivers with Existing Windows ME System
The following section details the installation of FastTrak100 drivers on a system that
has Millennium already installed and running. If you're installing the FastTrak100
drivers on a system during an installation of ME, see "Installing Drivers During
Windows ME Installation."
NOTE: If you have the FastTrak100 TX4, you will need to go through these steps
twice, since the TX4 appears as 2 controllers to the systems.
1.
After installing the FastTrak100 controller card and configuring the hard
drives, power up the system and boot.
2.
The "Add New Hardware Wizard" will appear, informing you that it has
found a "PCI RAID Controller."
3.
Click on "Next," and from the generated list box, choose "Search for a
better driver than the one your device is using now."
4.
Click on "Next," and from the generated choices, choose "Specify a
location."
5.
Insert the "FastTrak100 Driver" diskette in drive A:.
6.
Type "A:\WIN9x-ME" in the text box that appears.
7.
Click on "Next." A message in forming you that Windows Millennium has
found "Win9x -ME Promise FastTrak100 TX/LP(tm) Series Controller" should
appear.
8.
Click on "Next," and then on "Finish."
9.
Choose "Yes" when asked if you want to restart your computer. Be sure to
eject the diskette from drive A:.
Confirming Driver Installation in Windows ME
To confirm that the driver has been properly loaded in ME, perform the following steps:
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel," and then double -click on the "System" icon.
3.
Choose the "Device Manager" tab, and then click the "+" in front of "SCSI &
RAID controllers." "Win9x -ME Promise FastTrak100 TX/LP(tm) Series
Controller" should appear (2 listings will appear if you have the FastTrak100
TX4).
FastTrak100 TX/LP™ Series User Manual
41
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FASTtrak100 TX and is the answer not in the manual?