Checking Cmos Settings - Promise Technology FASTtrak100 TX User Manual

FastTrak100 TX/LP™ Series User Manual

Checking CMOS Settings

No changes are necessary in the Motherboard CMOS Setup for resources or drive
types. Since FastTrak100 is a PCI Plug-n-Play (PnP) device, the Interrupt and Port
address resources are automatically assigned by the Motherboard's PCI
PnP BIOS.
The FastTrak100 system resources including port address, interrupt, and BIOS
address are automatically determined by the system PnP BIOS. To customize
IRQ settings, enter the Motherboard BIOS's Advanced PCI setup and follow the
manufacturer's procedures. If the system has limited IRQ resources, the FastTrak100
card can be set for the same IRQ as other PCI cards if those cards support PCI
interrupt sharing.
If you wish to boot from a FastTrak100 drive array AND continue to use hard drives
attached to your motherboard's IDE controller, refer to your motherboard manual for
the specific BIOS settings to use in order to establish their proper boot order.
9