Table of Contents
Advertisement
3
175mm
3
1
2
a
Power switch for the domestic market
and general export
c, D
Power switch for JE
B
2) Remove table fixing bolts 3 whch are mounted
at two locatons of the table stand.
* The followng steps 3) through 7) are the re-
assembly procedure of the table.
3) Shft the table to adjust so that t laterally pro-
trudes from the end of the table stand by 175
mm. For the longtudnal drecton, also adjust so
that the table protrudes equally (approxmately 3
mm on each sde) from the end of table stand.
* If the table s not correctly postoned n the
longtudnal drecton, the throat plate auxlary
cover may not be removed.
4) Temporarily fix table fixing bolts 3 at two loca-
tons from the table stand sde.
5) Tghten screws 1 and 2 to mount the cover.
* If the cover and tapped hole do not algn, algn them
by movng the table.
* Tghten screw 2 after mountng the nut from the
undersde of the table.
6) Securely tighten the table fixing bolts at two
locatons from the table stand sde. (For refer-
ence: Tghtenng torque: 6 N•m)
7) After mounting the cover, attach the table fixing
bolt cover (accessory a) n poston.
B
9) Secure the operaton panel stoppers (accessory
c) n the punched locatons at near sde of the
rght table usng wood screws (accessory D).
– 5 –
8) Secure the power swtch
n the punched locaton
at the lower rght part
of the table usng wood
screws (accessory B).
Advertisement
Table of Contents
