Installing The Thread Stand; Installing The Air Hose; Installing The Eye Protection Cover - JUKI AMS-224E/IP-410 Instruction Manual

3-4. Installing the thread stand

a
B
table
1) Assemble the thread stand. Then, put t n thread-stand mountng hole a or B n the machne table.
2) Tghten locknut 1 to fix the thread stand.
3) When celng wrng s possble, pass the power cord through spool rest rod 2 .
4) If thread sags, use thread stand gude arm (asm.) 3 .

3-5. Installing the air hose

2
close
open

3-6. Installing the eye protection cover

WarNING :
Be sure to attach this cover to protect the eyes from the disperse of needle breakage.
2
1
2
1
1) Connectng the ar hose
1
Connect the ar hose to the regulator .
2) Adjustment of ar pressure
Open ar cock 1 , pull up and turn ar adjust-
ment knob 2 and adjust so that ar pressure
ndcates 0.5 to 0.55 MPa (Max. 0.55 MPa).
Then lower the knob and fix it.
* Close ar cock 1 to expel ar.
Use eye protecton cover 1 after securely attach-
ng t on face plate cover 3 wth screw 2 .
3
⇧
– 7 –
to prevent interference with the feed-
ing frame, be sure to install the thread
stand guide arm (asm.) with the eye
protection cover pressed in the direc-
tion of the arrow.
3