JUKI AMS-224E/IP-410 Instruction Manual page 21

4) Inserting direction of the media
1. When the inserting direction is wrong, panel or media may be damaged.
2. Do not insert any item other than the compactFlash(tM).
3. IP-410 corresponds to the compactFlash(tM) of 2GB or less.
4. IP-410 corresponds to the format Fat16 of compactFlash(tM). It does not correspond to
Fat32.
5. Be sure to use the compactFlash(tM) which is formatted with IP-410. For the formatting
procedure of the compactFlash(tM), see
2 After completon of settng of the meda, close the cover. By closng the cover, t s possble to ac-
cess. If the meda and the cover come n contact wth each other and the cover s not closed, check
the followng matters.
Check that the meda s securely pressed untl t goes no further.
•
Check that the nsertng drecton of the meda s proper.
•
cautions when using the compactFlash(tM)
• Do not wet or touch it with wet hands. Fire or electric shock will be caused.
• Do not bend, or apply strong force or shock to it.
• Never perform disassembling or remodeling of it.
• Do not put the metal to the contact part of it. Data may be disappeared.
• avoid storing or using it in the places below.
Place of high temperature or humidity / Place of dew condensation /
Place with much dust / Place where static electricity or electrical noise is likely to occur
Media
5) removing procedure of the media
1 Hold the panel by hand, open the cover, and press the
meda removng lever. The meda s eject.
2 When the meda s drawn out as t s, removng s com-
pleted.
– 17 –
1 Turn the label sde of the CompactFlash(TM)
to ths sde (place the notch of the edge to
the rear. ) and nsert the part that has a small
hole nto the panel.
"@-2-26. Performing formatting of the media",
When the lever is strongly pressed, the media may
be broken by protruding and falling.
p.69.