Installing The Panel; Attaching The Pedal Chain (For S Specification Only); Installing The Thread Stand - JUKI AMS-220EN / IP-420 Instruction Manual

3-7. Installing the panel

1) Installing the IP-420
❶
❷

3-8. Attaching the pedal chain (For S specification only)

❷
❸

3-9. Installing the thread stand

❷
❶
1) Open cover ❶ and remove cable ❷ once.
❸
Then connect it again to the panel on the top
surface of the table after passing it through the
hole in the table.
2) Fix operation panel installing plate ❸ to an op-
❹
tional place on the table with two wood screws
❹ .
Connect the machine ❶ and manual pedal ❸ with
chain ❷ .
❶
– 8 –
Install the panel at the position where
X-move cover or head grip does not
interfere with it since breakage of the
panel will be caused.
When you tilt the sewing machine, be
sure to tilt it after removing chain ❷
from manual pedal ❸ .
1) Assemble the thread stand, and put
it in the hole in the top left corner of
the machine table.
2) Tighten locknut ❶ to fix the thread
stand.
3) When ceiling wiring is possible, pass
the power cord through spool rest
rod ❷ .