Table of Contents
Advertisement
(2) Memory switch data list
No.
Multi-layered part detecting function enabled/disabled
Enable/disable of the multi-layered part detecting function is selected
with this switch.
Enable
Multi-layered part cutting position (front)
In the case, when the top of seam (i.e, joint) of a belt
loop is detected, the part of the belt-loop before the
detected seam is to be cut as a defective part, the
length of the part of the belt-loop to be cut is entered
with this switch (in mm). Since the area around the
seam is likely to bulge gradually toward the seam,
accuracy of the seam detection varies according
to the belt-loop material. This switch is provided to
compensate the detection accuracy.
In addition, this switch sometimes has to be adjusted
according to the belt-loop width.
* The front-side trimming of the multi-layered part is
only enabled when the front/rear is selected for the
multi-layered part trimming position. (memory switch
level 2 K551).
Refer to the Engineer's Manual for the memory
switch level 2. In the initial state, the front part of the
belt-loop is not cut.
Seam cutting position (rear)
The length of a belt-loop from the rear end of a
seam to the belt-loop cutting position is set with this
parameter (in mm).
Since the area around the seam is likely to bulge
gradually toward the seam, accuracy of the seam
detection varies according to the belt-loop material.
Adjust this parameter to around 10 to adjust the
aforementioned length to approximately 10 mm
according to the belt-loop material. If this length has
no allowance, the seam may remain on the belt loop.
Belt-loop multi-layered part detection display
initial value
This switch is used to set the initial value to
determine the multi-layered part of a belt loop for the
newly created belt loop pattern.
→ Refer to
p.50
for details.
Belt-loop no-insertion detection display
initial value
This switch is used to set the initial value to
determine no-belt-loop state for the newly created
belt loop pattern.
→ Refer to
p.50
for details.
Item
Disable
�@-2-13. Belt loop teaching function�,
�@-2-13. Belt loop teaching function�,
– 87 –
Input range/
Initial
selection range
value
―
Enable
0 to 99
10
(mm)
(mm)
0 to 99
10
(mm)
(mm)
0 to 255
70
0 to 255
0
Advertisement
Table of Contents
