Table of Contents
Advertisement
6-5. List of memory switch data
No.
U001 Soft-start function
The initial value differs with the machine head. (0: OFF)
U007 Bobbin thread count-down unit
0: 10 stitches / 1: 15 stitches / 2: 20 stitches
U013 Bobbin thread count stop function
0: Sewing machine start prohibition function is disabled even when the counter
completes counting (negative value).
1: When the counter completes counting, the sewing machine start after thread
trimming is prohibited.
2: When the counter completes counting, the sewing machine temporarily stops
and the start of sewing machine after thread trimming is prohibited.
* Note that the prohibition function is disabled in the case the initial value of
counter is 0 (zero).
U014 Sewing count function
1: Automatic sewing counter / 2: Sewing counter switch input
U021 Presser foot lift when the pedal is in its neutral position
0: Disabled / 1: Enabled / 2: Enabled only when the presser foot is at its lower
position / 3: Alternating vertical movement by depressing the back part of pedal
U025 Operation after manual turning (thread trimming)
This memory switch is used for setting the thread trimmer operation after the
sewing machine has moved from its upper/lower stop position by manual turning of
handwheel.
0: Permitted / 1: Prohibited
U030 Middle-of-sewing reverse feed stitching function
Midpoint-of-sewing reverse feed stitching function is set.
0: Without the midpoint-of-sewing reverse feed stitching function / 1: With the mid-
point-of-sewing reverse feed stitching function
U031 Number of stitches of middle-of-sewing reverse feed stitching
Number of midpoint-of-sewing reverse feed stitches is set.
U032 Condition of enabling middle-of-sewing reverse feed stitching while sewing
machine is at rest
Midpoint-of-sewing reverse feed stitching function enable condition
0: Disabled when the swing machine is at rest / 1: Enabled when the sewing ma-
chine is at rest
U033 Thread trimming activated by middle-of-sewing reverse feed stitching
Thread trimming function after the completion of midpoint-of-sewing reverse feed
stitching is set.
0: Without automatic thread trimming function / 1: With automatic thread trimming
function
U035 Minimum speed of the pedal
The initial value varies with the machine head.
U036 Thread trimming sewing speed
The initial value varies with the machine head.
U037 Speed during soft start
The number of revolutions set with this memory switch is given precedence even if
it is lower than the lowest speed by pedal.
The initial value varies with the machine head. (0:OFF)
One needle: 170 sti/min Two needles: 200 sti/min
U038 Speed during one-shot stitching
The maximum number of revolutions during soft start differs with the machine
head.
Item
– 81 –
Setting range
Unit
0 to 9
Stitch
0 to 2
Stitch
ー
0 to 2
ー
1 to 2
ー
0 to 3
ー
0 to 1
ー
0 to 1
1 to 19
Stitch
ー
0 to 1
ー
0 to 1
150 to 250
sti/min
100 to 250
sti/min
100 to 3500
sti/min
100 to 3500
sti/min
Advertisement
Table of Contents
