Table of Contents
Advertisement
No.
Shape Nos. 2,6: 2nd sewing position correction in
lateral direction of clamp
For shape Nos. 2 and 6, ths swtch s used to correct the
lateral poston of the belt loop clamp at the second sewng
poston.
Carry out the correcton f the belt-loop poston devates
from the sewng poston.
+: Belt loop s moved to the rght wth respect to the
sewng poston.
-: Belt loop s moved to the left wth respect to the sewng
poston.
Shape No. 6: 3rd sewing position correction in lateral
direction of clamp
For shape No. 6, ths swtch s used to correct the lateral
poston of the belt loop clamp at the thrd sewng poston.
Correct t f the belt loop and the sewng poston are not
algned.
+: Belt loop s moved to the rght wth respect to the
sewng poston.
-: Belt loop s moved to the left wth respect to the sewng
poston.
Shape No. 5, 7: Belt-loop rolling position correction in
terms of lateral direction of clamp
For shape No. 5 and 7, ths s the amount of lateral travel
of the belt loop clamp before removng the fork from the
belt loop.
Shape No. 7: Loosening amount after releasing rod
has moved, in terms of longitudinal direction of clamp
For sewng shape No. 7, t s the amount by whch the
garment-body tenson s reduced by movng the belt-loop
clamp forward after havng moved t to far sde to allow the
belt-loop releasng rod can be nserted.
Shape No. 3, 4, 5: Correction of longitudinal position
of belt loop clamp at second sewing position
For shape Nos. 3, 4 and 5, ths swtch s used to correct
the longtudnal poston of the belt loop clamp when
lowerng the work clamp of the machne head at the
second sewng poston.
Shape Nos. 4, 5: Correction of amount of moving belt
loop clamp to far side during second sewing
For shape Nos. 4 and 5, ths swtch s used to correct the
amount of movng the belt loop clamp to far sde durng
second sewng.
Manual pedal use: Amount of moving garment body feed
backward after garment body presser has come down
In the case the manual pedal has been programmed by
the devce settng data so that the front and rear garment
body pressers are drven separately and the garment body
feed travel s enabled after the garment body presser has
come down, ths s the amount of travel of the garment
body feed after the garment body presser has come down.
→ Refer to
detals of the devce settng data changng procedure.
*
: Data marked with an asterisk (*) are not displayed on the sewing data list screen. They are displayed,
however, from the data entry screen.
: Data in a gray box are not displayed in the standard state. To display them, refer to the Engineer's Manual.
Item
"@-2-29. How to set the device", p.91
– 85 –
Input range/
selection range
−3.0 to 3.0
(mm)
−3.0 to 3.0
(mm)
−3.0 to 3.0
(mm)
0 to 13.0
(mm)
−3.0 to 3.0
(mm)
−20.0 to 20.0
(mm)
0 to 20.0
(mm)
for
Initial
value
0
(mm)
0
(mm)
0
(mm)
0
(mm)
0
(mm)
0
(mm)
10.0
(mm)
Advertisement
Table of Contents
