Table of Contents
Advertisement
2-15. �unction of canceling grasping of a belt loop for the next sewing
This function is used to prohibit the setback operation after the end of sewing. In the case you know that
the power to the machine will be turned off after the end of sewing, or in the case you don't need to set-
back the next belt so as to change over the product, this function is used to prevent the next belt loop
from being grasped uselessly.
A
When press button
state (ON state)
end of sewing. When one sequence of belt-loop sewing is finished
in the ON state, the button is reset (OFF state).
In addition to the end of sewing as described above,
the cancellation of grasping of a belt loop for the next
sewing (prevention of the setback operation after the
end of sewing) can be reset from the state where but-
ton A is pressed in the following cases:
•
When the button, which is in the ON state, is
pressed again (to place it in the O�� state)
•
When the ready key is pressed on the sewing
screen (green) to return to the data entry screen
(blue);
•
When the power is turned O��;
•
When the error screen is displayed;
•
When you carry out sewing using the step operation
function (the screen changes to the step operation
selection screen).
– 55 –
A , the button is brought to the depressed
to prohibit the setback operation after the
Advertisement
Table of Contents
