Table of Contents
Advertisement
5-7. Method for changing the belt loop width
2
1
4
3
A
1
– 24 –
1)
When you want to change the belt loop wdth,
loosen two screws 2 of belt loop gude 1
to adjust the guide width to fit the belt loop
wdth.
Adjust so that the belt-loop passes through
the belt-loop gude smoothly wth no exces-
sve lateral space between the gude and the
belt loop, wth gude 1 pressed lghtly aganst
the belt loop.
Check that the top end of the belt loop gude
matches the belt loop wdth.
2)
Adjust the poston of gude 1 accordng to
the belt loop wdth.
3)
Loosen setscrew 4 of the belt loop clamp.
Adjust the poston of loop clamp, upper 3
accordng to the belt loop wdth.
The width of the belt loop guide sec-
tion and that of the belt loop clamping
section should be adjusted so that the
belt loop smoothly pass through and
that no widthwise play exists. If there
is an excessive widthwise play, the
belt loop attaching location can vary.
4)
Enter a value of belt loop wdth nto belt loop
wdth settng secton A on the operaton
panel screen. At the same tme, change the
dmensons of a seam for attachng a belt
"@-2-6. How to change the
loop. Refer to
belt loop length", p.38
changng the seam dmensons.
If the bartacking width of which is ex-
tremely wider than the bartacking width
setting specified through the operation
panel is sewn, the garment-body presser
and the belt-loop clamp can interfere with
each other (error No. M596). If the alarm
is given, change the bartacking width set-
ting to decrease the bartacking width.
for the method for
Advertisement
Table of Contents
