Table of Contents
Advertisement
2-10. How to name a belt loop pattern number
It is possible to enter as many as 14 characters for each belt loop pattern number.
A
B
C
D
7 �inishing the creation of a new pattern
When you press close button
mation entry screen, the screen goes back to the belt loop
data entry screen. Check to make sure that the parameters
you have set are included on the data entry screen.
If you press the cancel button on any of the screens
which appear on the steps of procedure beyond
the screen returns to the belt loop data entry screen.
In this case, the values of the parameters you have not
set shown on the belt loop data entry screen are their
initial values.
1 Displaying the data entry screen
Only on the belt loop individual sewing data entry screen (blue),
the name of a belt loop pattern number can be entered. On
the sewing screen (green), press the set ready key
display the data entry screen (blue).
2 Bringing up the character entry screen
When you press character entry button
acter entry screen is displayed.
3 Entering characters
Characters can be entered by pressing character button B
F
corresponding to the desired character. As many as 14 alpha-
numeric characters (
,
leftward-travel button
D . If you want to delete the entered character, move the
cursor to the character to delete and press delete button
E .
4 �inishing the entry of characters
When you press enter button
E
finished. After the end of the character entry, the characters
you have entered are displayed on the upper part of the data
entry screen (blue).
to
,
and
). The cursor can be moved by means of cursor
C or cursor rightward-travel button
– 46 –
O on the bartacking infor-
A , and the char-
to
) and symbols (
F , the character entry is
3 ,
to
,
,
Advertisement
Table of Contents
