Table of Contents
Advertisement
• Insyde Software (http://www.insydesw.com)
• Byosoft Co., Ltd (http://byosoft.com.cn/en/index.asp)
5.9
Operating System Installation
5.9.1
Windows* XP SP3
The Intel
legacy drivers and Windows* XP SP3 does not contain the required SATA AHCI driver
natively. Use the following instructions to install the Intel
driver during the installation of Windows XP SP3.
Note:
During the installation of Windows XP, only single USB device (the USB floppy disk) is
allowed to be connected to the system at USB port x23 else Windows XP installation
will not be successful. This is due to USB issue in the Intel
silicon. Refer to the Intel® Platform Controller Hub EG20T – Sightings Report for more
information. Some USB floppy drivers are not supported during F6 installation. See
details at http://support.microsoft.com/kb/916196.
1. Copy the files in 'FD_Inst_WinXP' in the SATA driver package to the root of a floppy
disk. The SATA driver package can be obtained from
http://edc.intel.com/Platforms/Atom-E6xx/#software.
— iohsata.cat
— iohsata.inf
— iohsata.sys
— txtsetup.oem
2. Make sure that the target computer has a compatible floppy drive.
3. Insert the floppy disk prepared in step 1 into the floppy drive.
4. Insert the Windows XP SP3 installer into the CD-ROM and boot from the CD-ROM to
start the Windows XP SP3 installation.
5. Press <F6> to add further SCSI/RAID drivers when prompted during the very early
stage of the Windows installation.
Figure 17.
Installing the Intel
6. Press <S> to add an additional SCSI device. Select the correct driver (Intel
EG20T SATA AHCI Controller for Windows XP) and press <ENTER> to continue the
®
Intel
Atom™ Processor E660 with Intel
User Manual
56
®
PCH EG20T SATA does not support an IDE interface that is compatible with
®
PCH EG20T SATA Driver - press F6
®
Platform Controller Hub EG20T Development Kit
®
PCH EG20T SATA AHCI
®
PCH EG20T A0 and A1
(Figure
17)
Software
®
PCH
January 2012
Document Number: 324213-002
Advertisement
Table of Contents
