Quick Start
6.3.2
Heat Sink Installation
Note:
All SKU except ULP (0.6GHz, 2.7W) parts require heat sink as cooling solutions.
1. Check heat sink and back plate for any visual defects prior to assembly.
Figure 24.
Heat Sink Components
2. Remove double sided tape sticker from back-plate. Attach the back plate onto the
bottom side of the PCB. Back-plate pins should be aligned to PCB holes.
3. A gap pad and sponge is provided with the heat sink assembly.
Note:
Thermal grease (TIM) is only needed when heat sink has been removed and reinstalled
or when the gap pad has been damaged.
4. Attach the gap pad and sponge to the center of the heat sink as shown in
Figure
Figure 25.
Back Side of the Heat Sink
January 2012
Document Number: 324213-002
25.
®
Intel
Atom™ Processor E660 with Intel
®
Platform Controller Hub EG20T Development Kit
User Manual
65