View Scsi Options - HP StorageWorks MSL5000 series User Manual

Operation
Figure 47: View SCSI options screen (two-drive model shown)
Table 7
tape drive locations
Table 7: View SCSI Options
Drive 0 Bus ID
Drive 1 Bus ID
Drive 2 Bus ID
(four-drive models
only)
Drive 3 Bus ID
(four-drive models
only)
86
lists and describes the available SCSI Options selections. (See
on page 21 for an illustration of the drive numbering scheme.)
Option
Lets you set the SCSI addresses of drive 0. The designators
Drive 0 (outer tape drive) through Drive n refer to the first
through nth drives, counting from right to left starting with
the master unit in a scaled Library system. Default is 1.
Lets you set the SCSI addresses of drive 1. The designators
Drive 1 (inner tape drive) through Drive n refer to the
second through nth drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 2.
Lets you set the SCSI addresses of drive 2. The designators
Drive 2 (lower, outer tape drive) through Drive n refer to
the third through nth drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 3.
Lets you set the SCSI addresses of drive 3. The designators
Drive 3 (lower, inner tape drive) through Drive n refer to
the fourth through nth drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 4.
HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Description
Library