HP StorageWorks MSL5000 series User Manual page 146

Troubleshooting
Table 11: Fault Symptom Codes (Continued)
FSC
3000 Motor Fault Condition
(One of the robot motors has been
disabled and could not be re-enabled.)
3002 Picker Tach Errors
(Picker tachometer errors were detected
when checking slots.)
3011 Bin Fetch Failure
(Loader failed to fetch a cartridge from a
bin.)
3013 Drive Fetch Failure
(Loader failed to fetch a cartridge from a
drive.)
146
Message
HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
ERP
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen. Wait 30 seconds to
power up again.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen. Wait 30 seconds to
power up again.
Press the Enter button to reboot.
Ensure cartridges are fully inserted in the
magazine(s).
Ensure that there are no obstructions
inside the library (all cartridges are in
magazines).
Run the cartridge cycle diagnostic to
verify.
Check the tape cartridge used in the last
operation for damage.
Press the Enter button to reboot.
Ensure the drive shows good status
through the drive status window.
Deactivate the drive using the GUI control
panel maintenance menu.
Reseat the drive.
Load/unload a cartridge to the drive to
verify.
Check the tape cartridge used in the last
operation for damage.
Run the cartridge cycle diagnostic to
verify.