Library Installation
Step 4: Connect the Library to the Host
Step 4: Connect the Library to the Host
1. Ensure that the host has been properly shut down and powered off.
2. Remove the back panel (lift up on the bottom of the panel, then pull
3. Use SCSI cables to connect the drives to the host, as explained in the
Table 2-3
Drive SCSI Connection Options
Library Model
DLT4000 2/28
DLT4000 4/48
DLT7000 2/28
DLT7000 4/48
4. Connect the library (bus 0) to a dedicated host SCSI card.
NOTE
Connecting other peripherals to the library or drive buses is not supported.
2-6
it away).
following table.
Non-daisy chained
Connect drive ports 1 and 2 to
their own host SCSI cards.
Connect drive ports 1, 2, 3, and
4 to their own host SCSI cards.
Connect drive ports 1 and 2 to
their own host SCSI cards.
Connect drive ports 1, 2, 3, and
4 to their own host SCSI cards.
SCSI Configuration
Daisy chained
Connect drive ports 1 and 2 together;
connect to a single host SCSI card.
Connect drive ports 1 and 2 together;
connect to a single host SCSI card.
Connect drive ports 3 and 4 together;
connect to a single host SCSI card.
Not supported
Not supported