HP StorageWorks MSL5000 series User Manual page 151

Table 11: Fault Symptom Codes (Continued)
FSC
3051 No Cartridges In Library
(No cartridge available for diag to run.)
3052 Too Many Cartridges
(Unable to run cartridge or drive cycle
because loader is full with cartridges.)
3054 Need 1 Drive Minimum
(No available drive to run diag.)
3057 Invalid Magazine Type
(Unsupported magazine type detected.)
3058 Magazine Type Change Not
Handled
(Unsupported magazine type detected.)
3059 Drive Type Not Supported
(Unsupported magazine type detected.)
HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Message ERP
Press the Enter button to clear the
message.
Insert cartridge.
Invalid user initiated operation. Set
parameters correctly and try again.
Press the Enter button to clear the
message.
Remove a tape from the library.
Invalid user initiated operation. Set
parameters correctly and try again.
Install or activate a drive.
Press the Enter button to clear the
message.
Invalid user initiated operation. Set
parameters correctly and try again.
Upgrade firmware if a newer revision
exists.
Press the Enter button to clear the
message.
Invalid user initiated operation. Set
parameters correctly and try again.
Upgrade firmware if a newer revision
exists.
Press the Enter button to clear the
message.
Invalid user initiated operation. Set
parameters correctly and try again.
Upgrade firmware if a newer revision
exists.
Press the Enter button to clear the
message.
Invalid user initiated operation. Set
parameters correctly and try again.
Troubleshooting
151