HP StorageWorks MSL5000 series User Manual page 150

Troubleshooting
Table 11: Fault Symptom Codes (Continued)
FSC
3031 Chassis S/N Mismatch. Previous
S/N retained
(The serial number scanned from the bar
code label does not match the value stored
in non-volatile memory.)
3032 Chassis S/N Character count is
not correct
(A valid serial number bar code label
could not b read.)
3033 Chassis S/N did not scan
(A valid serial number bar code label
could not be read.)
3034 Chassis S/N save operation
failed
(The serial number scanned from the bar
code label could not be saved to
non-volatile memory.)
3040 Motor Firmware Error
(The loader task detected an unexpected
status and could not recover.)
3041 Loader Received Invalid
Command
(The loader task received an unexpected
command and could not recover.)
3042 Motor Firmware Error
(The loader task detected an unexpected
status and could not recover.)
3050 Missing Magazine
(In diag, no magazine installed for diag to
run.)
150
Message
HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
ERP
Press the Enter button to clear the
message.
No action is required. This error is
expected when replacing the controller
board. If controller board was not
replace, then contact support.
Press the Enter button to clear the
message.
Contact support.
Press the Enter button to clear the
message.
Contact support.
Press the Enter button to clear the
message.
Contact support.
Press the Enter button to reboot.
Turn off power to the library and inspect
connectors and cables.
Press the Enter button to reboot.
Turn off power to the library and inspect
connectors and cables.
Press the Enter button to reboot.
Turn off power to the library and inspect
connectors and cables.
Press the Enter button to clear the
message.
Insert magazine.
Invalid user initiated operation. Set
parameters correctly and try again.