Hp Command View Evaperf Command Options; Running Hp Command View Evaperf - HP EVA P6000 Software Manual

HP Command View EVAPerf command options

Use the following options with the HP Command View EVAPerf commands:
-csv: Uses comma-separated output. This format is useful for importing large amounts of data
into a spreadsheet for analysis.
-cont n: Runs the command continuously at an interval specified by n. The default interval
is one second.
-dur n: Specifies the duration of a continuous mode session. For example, if you enter
evaperf hps -cont 2 -dur 30, host port data is displayed at two-second intervals for
a total of 30 seconds.
-sz array: Limits data collection to the specified array(s). You must specify at least one
array; use the array World Wide Name (WWN) or friendly name.
-fo filename: Directs output to a specified file. Include the path information as necessary.

Running HP Command View EVAPerf

1. Double-click the HP Command View EVAPerf icon on the desktop. The HP Command View
EVAPerf command window opens.
2. Enter the following command to capture and display the total IOPS (Req/s) and throughput
(MB/s), where n is the interval in seconds and m is the duration in seconds:
evaperf as -cont n dur m sz array -fo filename
Specify an interval and duration that will enable you to view a period of low I/O activity. For
example, collect data once every 10 minutes for a period of 6 hours when you plan to do the
upgrade to familiarize yourself with characteristic I/O and throughput values. For example,
the following command will capture data at 10–minute intervals (60*10) for 6 hours (60*60*6)
on an array named EVA1, and store the output in a file named EVA_upgrade:
evaperf as
You can store the data in a folder or drive of your choice.
(To see your own friendly names, run HP Command View EVAPerf with the fnh command
and list the names with the ls command.)
cont 600 dur 21600 sz EVA1 -fo C:\EVA_upgrade
Selecting a time to perform an online upgrade 23