HP StorageWorks MSL5000 series User Manual page 161

Table 11: Fault Symptom Codes (Continued)
FSC
503D Drive Status Fail
(Cleaning operation failed because the
library could not retrieve drive status.)
7001 Command response from
unexpected source
7002 Control command execution
failed
7003 Control response not matched
to a known command
7004 Loader response not matched to
a known command
7005 Drive response not matched to
a known command
7006 Flash response not matched to
a known command
7007 Drive index on Update Status
message was invalid
7008 The Drive response was not
expected
HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Message ERP
Press the Enter button to clear the
message.
Invalid user initiated operation. Set
parameters correctly and try again.
Ensure the drive shows good status
through the drive status window.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Ensure the drive shows good status
through the drive status window.
Press the Enter button to reboot.
Cycle power to the library or reboot using
the GUI touch screen.
Ensure the drive shows good status
through the drive status window.
Troubleshooting
161