Audio Adjust - Marantz SR6006 Owner's Manual

Audio Adjust

n Surround Parameters
The items (parameters) that can be adjusted depend on the signal being input and the currently
set surround mode. For details on the adjustable parameters, see "Surround modes and surround
parameters" (vpage 132).
NOTE
• Some setting items cannot be set while playback is stopped. Make the settings during playback.
• You cannot set the surround parameters in the PURE DIRECT mode.
Setting items
ON : "HT-EQ" is used.
HT-EQ
Soften the treble range OFF : "HT-EQ" is not used.
of movie soundtracks for
better understanding.
Buttons on the remote control unit can be used
for operations.
AMP
q Press
AMP-operation mode.
HT-EQ
w Press
DRC Auto : Automatic dynamic range compression on/off control according to
Compress dynamic range source. This can be set in the Dolby TrueHD mode.
(difference between loud Low / Middle / High : These set the compression level.
and soft sounds). OFF : Dynamic range compression always off.
D.COMP OFF : Turn dynamic range compression off.
Compress dynamic range Low / Middle / High : These set the compression level.
(difference between loud
and soft sounds).
LFE –10dB – 0dB
Adjust the low-frequency
For proper playback of the different sources, we recommend setting
effects level (LFE).
to the values below.
• Dolby Digital sources : "0dB"
• DTS movie sources : "0dB"
• DTS music sources : "–10dB"
BD
Default settings are underlined.
Setting details
to set the remote control unit to
.
Setting items
Center Image 0.0 – 1.0 (0.3)
Assign center channel
signal to front left and right
channels for wider sound.
Panorama ON : Set.
Assign front L/R signal also OFF : Do not set.
to surround channels for
wider sound.
Dimension 0 – 6 (3)
Shift sound image center
to front or rear to adjust
playback balance.
Center Width 0 – 7 (3)
Assign center channel
signal to front left and right
channels for wider sound.
Height Gain Low : Reduce the front height channel volume.
Control the front height Middle : Front height channel sound is output with standard sound
channel volume. volume.
High : Increase the front height channel volume.
NOTE
"Height Gain" is displayed for the following settings.
• When "Amp Assign" (vpage 101) is set to "F.Height".
• When the "Speaker Config." – "Front Height" setting (vpage 102) is
set other than to "None".
• When surround mode is "PLgz" or the PLgz decoder is used.
Default Yes : Reset to the defaults.
The "Surround Parameters" No : Do not reset to the defaults.
settings are returned to the
When you select "Default" and press
default settings.
the "Return all settings to the default?"
prompt is displayed. Select either "Yes" or
"No", and press
95
AUDIO/VIDEO ADJUST
Setting details
ENTER
,
ENTER
.