Marantz SR6006 Owner's Manual page 99

n Tone
Adjust the tonal quality of the sound.
Setting items
Tone Control ON : Allow tone adjustment (bass, treble).
Set the tone control function OFF : Playback without tone adjustment.
to ON and OFF.
"Tone Control" can be set when "Dynamic EQ ® "
set to "OFF".
NOTE
• "Tone Control" settings are not reflected to ZONE2 and ZONE3.
• The tone cannot be adjusted in the "DIRECT" mode.
Bass –6dB – +6dB
Adjust low frequency range
"Bass" can be set when "Tone Control" is set to "ON".
(bass).
Treble –6dB – +6dB
Adjust high frequency range
"Treble" can be set when "Tone Control" is set to "ON".
(treble).
BD
Setting details
(vpage 97) is
n Audyssey Settings
Set Audyssey MultEQ ® XT, Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® . These can be
selected after Audyssey ® Auto Setup has been performed. For additional information on Audyssey
technology, please see page 138.
NOTE
• If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup,
you may not be able to select Dynamic EQ ® /Dynamic Volume ® .
In this case, either perform Audyssey ® Auto Setup over again or perform "Restore" (vpage 26) to
return to the settings after Audyssey ® Auto Setup was run.
• When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the "Audyssey
Settings" cannot be set.
Setting items
MultEQ ® XT
Audyssey : Optimize the frequency response of all speakers.
MultEQ ® XT corrects
Audyssey Byp.L/R : Optimize frequency response of speakers except
both time and frequency front L and R speakers.
response problems in the Audyssey Flat : Optimize frequency response of all speakers to flat
listening area based on response.
Audyssey ® Auto Setup
Manual : Apply frequency response set with "Manual EQ" (vpage 98).
OFF : Turn "MultEQ ® XT" equalizer off.
calibration. We recommend
"Audyssey".
"Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be
MultEQ ® XT is the
selected after Audyssey ® Auto Setup has been performed.
prerequisite function for
Dynamic EQ ® and Dynamic
NOTE
Volume ® .
• "MultEQ ® XT" and "Manual" cannot be selected when "EQ Customize"
is set to "Not Used" (vpage 106).
• When using headphones, "MultEQ ® XT" is automatically set to "OFF".
"MultEQ ® XT", "Dynamic EQ ® " and "Dynamic Volume ® " settings are stored for each input source.
96
AUDIO/VIDEO ADJUST
Default settings are underlined.
Setting details
vSee overleaf