Connection; Playback - Marantz SR6006 Owner's Manual

4
Use o p to select the
configuration of the connected
speakers.
NORMAL Select the "NORMAL" setting to perform 7.1-channel
playback using the surround back, front height, or
front wide speakers.
ZONE2 Select the "ZONE2" setting to assign the unit's built-
in power amplifier for ZONE2 and output the audio
in stereo.
ZONE3 Select the "ZONE3" setting to assign the unit's built-
in power amplifier for ZONE3 and output the audio
in stereo.
SPKR-C Select the "SPKR-C" setting to connect the front
speakers via the bi-amp connection.
F.Height Select the "F.Height" setting to use the front height
speaker for playback.
F.Wide Select the "F.Wide" setting to use the front wide
speaker for playback.
5
Press RETURN to exit the "Amp Assign" setting.
6
Set up "Channel Select"
Use ui to select "Channel Select", and then press
ENTER
.
AUDYSSEY AUTO SETUP
STEP1 Preparation 1 2 3 4 5 6
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter Cancel
RETURN
Enable skip of measuring unused channels to reduce time
AUDYSSEY AUTO SETUP
Channel Select
STEP1 Preparation 1 2 3 4 5 6
Connect the speakers and place them according Subwoofer Measure
to the recommendations in the manual,
Surround Back Measure (2spkrs)
Set the following items
If necessary.
Amp Assign
Channel Select
Measure subwoofer channel
Auto Setup Start
Enter
Cancel
RETURN
Enter Cancel
RETURN
Enable skip of measuring unused channels to reduce time
65
7
Use ui to select a channel.
Subwoofer Select for no subwoofers to be used. In this case, go
to step 8.
Surround
Select the number of surround back speakers to be
Back
used. In this case, go to step 9.
• "Surround Back" can be set when "Amp Assign" is
set to "NORMAL".
8
o p
Use to set whether or not a subwoofer channel
is measured.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
9
Use o p to set whether or not a surround back
channel is measured.
Measure
Set for measuring two surround back speakers.
(2 spkrs)
Measure
Set for measuring a surround back speaker.
(1 spkr)
Skip
Set for no measuring of a surround back speaker.
10
RETURN
Press .
Proceed to page 22 STEP1 Preparation
NOTE
After performing Audyssey ® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey ® Auto Setup again.
Set up speakers
step 6.