Marantz SR6006 Owner's Manual page 25

STEP 1
Preparation
4
Connect the setup microphone to the SETUP MIC
jack of this unit.
When the setup microphone is
connected, the following screen is
displayed.
AUDYSSEY AUTO SETUP
STEP1 Preparation 1 2 3 4 5 6
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter Cancel
RETURN
Start Auto Setup
Here, we explain setup using the example of 7.1-channel speaker
playback using surround back speakers.
For setup of surround speaker systems other than 7.1-channels,
follows steps 3 and 4 in "Set up "Amp Assign"" (vpage 64).
If unused channels are set with "Channel Select", measuring time
can be shortened. For setting, perform steps 6 to 9 of "Set up
"Channel Select"" (vpage 65).
5
Use i to select "Auto Setup
ENTER
Start" and then press .
STEP 2
Detection & Measurement (Main)
• In STEP 2, you will perform measurements at the main listening
position.
• This step automatically checks the speaker configuration and speaker
size, and calculates the channel level, distance, and crossover
frequency.
It also corrects distortion in the listening area.
6
Select "Measure" and then press
When measuring begins, a test tone is output from each
speaker.
• Measurement requires several minutes.
7
The detected speakers are displayed.
• The illustration below shows an example of when the front
speakers, center speaker, subwoofer, and surround speakers have
been detected.
AUDYSSEY AUTO SETUP
STEP2 Speaker Detection Check 1 2 3 4 5 6
Front Yes
Center Yes
Subwoofer Yes
Surround Yes
Surround Back 2spkrs
Retry
Next Measurement
Enter Cancel
RETURN
Proceed to next after checking speaker connection result
NOTE
If a connected speaker is not displayed, the speaker may not be
connected correctly. Check the speaker connection.
8
i
Use to select "Next → Measurement" and then
press ENTER .
22
NOTE
If "Caution!" is displayed:
Go to "Error messages"
check any related items, and perform the
necessary procedures.
If the problem is resolved, return and restart
"Audyssey ® Auto Setup".
ENTER .
When performing Audyssey ® Auto Setup over
again
ui
Press to select "Retry", and then press
When measuring has stopped
RETURN
q Press
o
w Press to select "Yes", then press
Setting up the speakers again
Repeat the operation from step 4 of STEP 1 Preparation
Set up speakers (Audyssey ® Auto Setup)
(vpage 25),
ENTER
.
, to the "Cancel auto setup?" prompt is displayed.
ENTER
.
.
vSee overleaf