Playback In Zone2/Zone3 (Separate Room); Audio Output - Marantz SR6006 Owner's Manual

Playback in ZONE2/ZONE3 (Separate room)

• You can operate this unit so as to enjoy audio in a room (ZONE2, ZONE3) other than the MAIN ZONE
(room where the unit is located).
• You can simultaneously play back the same source in both the MAIN ZONE, ZONE2 and ZONE3. You can
also play back separate sources in the MAIN ZONE, ZONE2 and ZONE3.
The source selected for ZONE2 is also output from the recording output connectors.

Audio output

There are two methods to do this, as described below. Choose one of the methods.
q Zone playback by speaker output
w Zone playback by audio output (PRE OUT)
Use an external amplifier.
q Zone playback by speaker output
The ZONE2 and ZONE3 audio signals are output from this unit's SURR.BACK/AMP ASSIGN speaker
terminals using the amplifier assignment function.
n Connecting and setting the speakers
"Amp Assign" setting (vpage 101)
and audio signals output
Output signal :
ZONE2 ZONE2
Stereo (L / R)
Output signal :
ZONE3 ZONE3
Stereo (L / R)
BD
w Zone playback by audio output (PRE OUT)
n Audio connections (ZONE2, ZONE3)
The audio signals of this unit's ZONE2 and ZONE3 audio output terminals are output to the ZONE2 and
ZONE3 amplifiers and played on these amplifiers.
We recommend using high quality pin-plug cables for audio connections in order to prevent noise.
NOTE
Connecting the speakers
• When the input source to which the digital input connectors (OPTICAL/COAXIAL) are assigned is selected
in ZONE2 or ZONE3, playback is only possible if the digital signal being input is in PCM (2-channel) format.
ZONE2
• It is not possible to play the digital audio signals input from the HDMI terminals in ZONE2 and ZONE3.
Use analog connections for ZONE2 or ZONE3 playback.
• When certain digital signals are being input, noise may be output from the ZONE2 and ZONE3 audio
(L) (R)
output connectors.
w q w q
ZONE3
(L) (R)
w q w q
79
MAIN ZONE
L
R
ZONE2
This unit
AUX IN
L
R
ZONE3
AUX IN