Set Up Speakers - Marantz SR6006 Owner's Manual

Set up speakers

This section provides the setup methods of speaker systems other than the 7.1-channel system with surround back speakers.
For the setup methods of the 7.1-channel system with surround back speakers, see
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers
"Set up "Channel Select"").
1
Set up the
remote control unit
n Set up the operation mode
AMP
Press to set the remote control unit to AMP-
operation mode.
Press AMP
C page 4 "SETUP WIZARD".
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter Cancel
RETURN
Start Auto Setup
64
around items indicate the settings.
(vpage 64 "Set up "Amp Assign"").
3
Set up "Amp Assign"
ui
Use to select "Amp Assign", and then press
ENTER .
AUDYSSEY AUTO SETUP
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter
Change assigned power amp to match the speaker system
AMP ASSIGN
Assign Mode NORMAL
ZONE2:
5.1 ch/7.1 ch
(vpage 65
1 2 3 4 5 6
Cancel
RETURN
[1/2]
ZONE3:
Return
RETURN
vSee overleaf