Marantz SR6006 Owner's Manual page 107

Setting items
Crossover Freq. 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
Set the maximum frequency 250Hz : Set the crossover frequency.
of the bass signal output
Advanced : Specify crossover frequency for each speaker.
from each channel to
• Front / Center / Surround / Surr.Back / Front Height / Front Wide
the subwoofer. Set the
: Select the speaker.
Crossover Frequency to
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
suit the bass reproduction
250Hz : Set the crossover frequency.
capability of the speaker
being used.
• "Crossover Freq." can be set when the "Bass Setting" – "Subwoofer
Mode" (vpage
speaker that is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Advanced" is selected differ
depending on to the "Subwoofer Mode" setting (vpage 102).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
BD
Setting details
102) setting is "LFE+Main", or when you have a
HDMI Setup
Make settings for HDMI video/audio output.
Setting items
Auto Lip Sync ON : Compensated.
Make automatic OFF : Not compensated.
compensation for timing
shift in audio and video
output.
HDMI Audio Out Amp : Play back through speakers connected to the unit.
Select HDMI audio output TV : Play back through TV connected to the unit.
device.
• The audio signal input from the HDMI input connector can be output as
an output signal from the HDMI output connector by setting the HDMI
audio output destination to TV.
Audio signals input via the Analog/Coaxial/Optical input connectors
cannot be output from the HDMI output connector.
• When the HDMI control function is activated, priority is given to the TV
audio setting
Monitor Out Auto (Dual) : The presence of a TV connected to the MONITOR 1 or
Make settings for HDMI MONITOR 2 terminal is detected automatically, and that TV connection
monitor output. is used.
Monitor 1 : A TV connected to the MONITOR 1 terminal is always used.
Monitor 2 : A TV connected to the MONITOR 2 terminal is always used.
• If both the Monitor 1 and 2 connectors are connected and "Resolution"
(vpage 90) is set to "Auto", the signals are output with a resolution
compatible with both TV.
• With "Resolution"
the TV you are using is compatible with the resolution under "HDMI
Information" – "Monitor 1" and "Monitor 2" (vpage 116).
NOTE
Depending on the monitor you have connected, the display may not
be correct when you set to "Auto (Dual)". In such a case, set to either
"Monitor 1" or "Monitor 2".
104
SYSTEM SETUP
Default settings are underlined.
Setting details
(vpage 68 "HDMI control function").
(vpage 90) not set to "Auto", check whether
vSee overleaf