Operating Learn Function - Marantz SR6006 Owner's Manual

Operating learn function

• This remote control unit is capable of learning and storing codes
used by other remote controls that you already own.
• If the AV device is not a marantz device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered
for use by the marantz remote control included with this device.
• This remote control unit is capable of learning around 60 codes.
Learning procedure
1
Place the marantz remote control and remote control
from the other device approximately 5 cm apart,
with the remote control signal transmission sections
facing each other.
5 cm
2
SET SURROUND
Press and hold down and
LEARN indicator blinks.
3
Press input source select buttons (
CD
or ) to select the input source.
4
Select the button to be learned.
The LEARN indicator lights.
NOTE
• The learning function is unavailable for all
SOURCE Z /X
and
• The learning function is unavailable for all
buttons in TUNER mode, NET/USB mode
and AMP mode.
5
Press and hold the button of the
original remote control unit to be
learned until the SEND indicator
blinks twice.
• When the SEND indicator blinks once again, the transmitting code
is unavailable for remote control unit, or the transmitting signal has
been interrupted by noise.
• If the SEND indicator blinks once, repeat this step.
• When the memory of the remote control unit is full, the LEARN and
SEND indicators blink once. If you want to learn the code, you need
to erase a different learned button.
until the
NOTE
If the LEARN indicator flashes when the SEND indicator is lit, then
the button cannot be learned.
BD , DVD , SAT , TV ,
6
Repeat steps 4 and 5 to learn other buttons for the
same input source.
DISP
in any mode.
123
7
Repeat steps 3 to 6 to learn other input sources.
8
When programming of the remote control unit is
completed, press SET .
The LEARN display disappears, and the remote control unit
exits learn mode.
NOTE
• The learning function is unavailable for all buttons in TUNER mode,
AMP mode, NET/USB mode and M-XP mode.
• The learning procedure does not operate correctly if the batteries
have become worn.
• If no buttons are pressed for approximately 1 minutes while in the
LEARN mode, the remote control unit automatically exits from the
LEARN mode.