Marantz SR6006 Owner's Manual page 24

1
Set up the microphone
Mount the setup microphone on a tripod or stand
and place it in the main listening position.
When placing the setup microphone, adjust the height of the
sound receptor to the level of the listener's ear.
Sound receptor
Setup
microphone
If you do not have a tripod or stand, set up the microphone on, for
example, a seat without a back.
NOTE
• Do not hold the setup microphone in your hand during
measurements.
• Avoid placing the setup microphone close to a seat back or wall as
sound reflections may give inaccurate results.
2
Set up the subwoofer
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
n When using a subwoofer with a direct mode
Set the direct mode to "On" and disable the volume adjustment
and crossover frequency setting.
n When using a subwoofer without a direct mode
Make the following settings:
• Volume : "12 o'clock position"
• Crossover frequency : "Maximum/Highest Frequency"
• Low pass filter : "Off"
• Standby mode : "Off"
NOTE
When you use two subwoofers, please adjust the subwoofer
volume controls individually so that each subwoofer level is as close
as possible to 75 dB using the test tone
Audyssey ® Auto Setup.
21
3
Set up the remote control unit
n Set up the operation mode
Press AMP
operation mode.
(vpage 103) before
Set up speakers (Audyssey ® Auto Setup)
to set the remote control unit to AMP-
Press AMP
vSee overleaf