Set Up Speakers - Marantz SR5005 User Manual

Set up speakers

This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).
For the setup methods of the 7.1-channel system with surround back speakers, see "Set up speakers (Audyssey® Auto Setup)" (vpage 6) of "Simple
version".
First install and connect the speakers to this unit.
1
Set up
the remote control unit
n Set up the operation mode
Press AMP to set the remote control
unit to amplifier operation mode.
Press AMP
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
3-1.Audyssey Auto Setup
MultEQ
Please place microphone
at ear height at
main listening position.
F.Height : Measure
Front Sp. : A
Amp Assign: Normal
Start
Cancel
[ENT]:Select [RTN]:Back
Remote control operation
buttons
SVENSKA SVENSKA NEDERLANDS NEDERLANDS
3
Set up "Amp Assign"
Use to select "Amp Assign".
ui
3-1.Audyssey Auto Setup
MultEQ
Please place microphone
at ear height at
main listening position.
F.Height : Measure
Front Sp. : A
Amp Assign: Normal
Start
Cancel
[RTN]:Back
4
Use to select the configuration
o p
of the connected speakers.
Set when using 7.1-channel
Normal
(Front/Center/Surround/Surround
Back or Front height/Subwoofer)
speakers.
Set for connecting the speakers
ZONE2
for ZONE2 to the SURR. BACK/
AMP ASSIGN terminals.
Set for connecting a tweeter of
SPKR-C
a front speaker to the SURR.
BACK/AMP ASSIGN terminals
and a woofer of the front speaker
to the FRONT A terminals.
5
Set up "F. Height"
Press u to select "F. Height".
Set to measure the front height
Measure
speakers.
Set not to measure the front
Skip
height speakers.
Move the cursor
(Up/Down/Left/Right)
ESPAÑOL ESPAÑOL ITALIANO ITALIANO
around items indicate the settings.
6
Set up "Front.Sp."
Use ui to select "Front Sp." and
then press o p to select a speaker.
A Select this to use front speaker A.
B
Select this to use front speaker B.
A+B Select this to use front speakers A and B
simultaneously.
NOTE
If "Mesure" is selected in step 5, select "A". If
"B" is selected, the "F.Height" measurement
cannot be performed.
7
Proceed to page 8
" Preparation " step 5.
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Confirm the setting
FRANÇAIS FRANÇAIS DEUTSCH DEUTSCH
Return to previous menu
ENGLISH ENGLISH
37