Ip Addressing; To Set Up And Install The Switch In Your Network; Physical Installation; Need Only A Quick Start - HP PROCURVE 2520 Management And Configuration Manual

Getting Started

Need Only a Quick Start?

Need Only a Quick Start?

IP Addressing

If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using VLANs, ProCurve recommends that
you use the Switch Setup screen to quickly configure IP addressing. To do so,
do one of the following:
■
■
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.
To Set Up and Install the Switch in Your
Network

Physical Installation

Use the ProCurve Installation and Getting Started Guide for the following:
■
■
■
■
For the latest version of the Installation and Getting Started Guide for your
switch, refer to "Getting Documentation From the Web" on page 1-6.
1-8
Enter setup at the CLI Manager level prompt.
Procurve# setup
In the Main Menu of the Menu interface, select
8. Run Setup
Notes, cautions, and warnings related to installing and using the switch
and its related modules
Instructions for physically installing the switch in your network
Quickly assigning an IP address and subnet mask, set a Manager pass­
word, and (optionally) configure other basic features.
Interpreting LED behavior.