System Configuration Settings - Qlogic SANbox 5000 Series Interface Manual

14 – Command Reference
Set Setup System
Set Setup System
Configures the network, session, and logging settings on the switch.
Authority
Admin session
Syntax
set setup system
Prompts you in a line-by-line fashion to change system configuration settings.
Table 14-26
a new value or press the Enter key to accept the current value shown in brackets.
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
EthNetworkEnable
EthNetworkDiscovery
EthNetworkAddress
EthNetworkMask
EthGatewayAddress
AdminTimeout
InactivityTimeout
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
14-106
describes the system configuration fields. For each parameter, enter
Table 14-26. System Configuration Settings
Entry
Enables (True) or disables (False) the Ethernet port. The
default is True.
Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Ethernet subnet mask address. The default is 255.0.0.0.
Ethernet IP address gateway. The default is 10.0.0.254
Amount of time in minutes the switch waits before termi-
nating an idle Admin session. Zero (0) disables the time
out threshold. The default is 30, the maximum is 1440.
Amount of time in minutes the switch waits before termi-
nating an idle Telnet command line interface session.
Zero (0) disables the time out threshold. The default is 0,
the maximum is 1440.
Enables (True) or disables (False) the saving of log infor-
mation on the switch. The default is True.
Enables (True) or disables (False) the recording of the
switch event log on a remote host that supports the sys-
log protocol. The default is False.
The IP address of the host that will receive the switch
event log information if remote logging is enabled. The
default is 10.0.0.254.
Description
S
59183-02 A